AirTools 2X Voice Processor

Features
• Two (2) independently programmable
channels of ultra-low latency digital
microphone processing in one rack space.
• Two (2) Mic/Line inputs, two (2) Mic/Line
outputs, two (2) AES3 outputs, Word
Clock input.
• Processing modules include Compression,
Equalization, De-Essing, Downward
Expansion, Highpass and Lowpass filters,
and Voice Symmetry.
• Configure named presets for each on-air
personality – up to 50, including factory
presets – using the included Windows®
software over Ethernet.
• Recall presets with convenient front panel
controls, optional hardware remote(s), or
third-party control protocol.

Performance Data
INPUTS
Nominal Input Level: +4 dBu or -10 dBV line level, to -50 dBu mic level
(software selectable) with 20 dB of headroom
Maximum Input Level: +23 dBu
Input Impedance: 6.67 kΩ balanced, > 3.3 kΩ unbalanced
CMRR: > 75 dB @ 1 kHz, unity gain
Mic Pre-amp EIN:> -127 dB, 22 Hz - 22 kHz, 100 Ω source impedance
Phantom Power: +48 VDC
A/D Conversion: 24-bit delta/sigma
A/D Dynamic Range: 116 dB (A-Weighted)
A/D THD+Noise: -102 dB (un-weighted); 1 kHz @ -2 dBFS with 0 dB gain
A/D Latency: 0.25 mS

OUTPUTS
Nominal Output Level:
Analog: +4 dBu line level with 20 dB of headroom
Digital: -20 dBFS. For unbalanced analog output, float (do not connect) the
minus output terminal. Unbalanced usage results in 6 dB lower output level.
Maximum Output Level:
Analog: +24 dBu. Digital: 0 dBFS
Output Impedance:
Analog: 200 Ω balanced, 100 Ω unbalanced. Digital: 110 Ω
D/A Conversion: 24-bit delta/sigma
D/A Dynamic Range: 114 dB (A-Weighted)
D/A THD+N: -98 dB (un-weighted); 1 kHz @ -2 dBFS
D/A Latency: 0.2 mS
Mic Level Output Pad (Internal): -42 dB

SYSTEM
Nominal Sampling Rate: 48 kHz
Word Clock Input Range: 22 - 192 KHz
A/D/A Frequency Response: 20 Hz - 20 kHz, +/- 0.25 dB
A/D/A Dynamic Range: 113 dB (A-Weighted)
A/D/A Latency: < 0.7 mS; with all DSP active
Interchannel Crosstalk: > -90 dB @ 1 kHz, typical

Mechanical Data
Space Required:
1U (WDH: 48.02 cm x 23.11 cm x 4.37 cm / 18.91 in
x 9.1 in x 1.72 in), depth is specified from front panel
to back of connectors.
Allow at least 3 inches additional clearance for rear
panel connections. Additional depth may be required
depending upon your specific wiring and connections.

Electrical:
100-240 VAC, 50/60 Hz, 25 Watts maximum.
No line voltage switching required.